Aluprof AL-RSP 01 프로그래밍 매뉴얼 - 페이지 5

{카테고리_이름} Aluprof AL-RSP 01에 대한 프로그래밍 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aluprof AL-RSP 01 6 페이지. Underplaster radio controller

페이지 인쇄

6. MODE OF LIGHTNING CONTROL OPERATION

6.1. PROGRAMMING OF THE FIRST TRANSMITTER

By turning on power supply

Turn on the power, which will be

confirmed by a short voltage

supply to the W1 or W2

output.

With the programming button

While the power supply is ON press

3x the PROG programming

button , which will be confirmed by

the LED.

III

With a switch

While the power supply is

ON quickly press 3x "UP" or "DOWN"

button on the switch, which will

be confirmed by a short voltage

supply to the W1 or W2

output.

6.2. ADDING ANOTHER TRANSMITTER

Press "P2" button twice of the already

programmed transmitter, which

will be confirmed by a short

voltage supply to the W1 or W2

output.

We reserve the right to any technical change.

Valid on 2022.05.23

PROGRAMMING MANUAL FOR UNDERPLASTER RADIO CONTROLLER AL-RSP 01

In the interval of two seconds

press the button

"P2" (1xP2 for W1, 2xP2 for W2),

which will be confirmed by

applying brief voltage pulses

to the output W1 or W2

In the interval of two seconds

press the button

"P2" (1xP2 for W1, 2xP2 for W2),

which will be confirmed by

applying brief voltage pulses

to the output W1 or W2

In the interval of two seconds

press the button

"P2" (1xP2 for W1, 2xP2 for W2),

which will be confirmed by

applying brief voltage pulses

to the output W1 or W2

Press the "P2" button of

the new transmitter,

which will be confirmed

by a short voltage supply to the

W1 or W2 output.

Press "UP" button , which

will be confirmed by a short

voltage supply to the

W1 or W2 output.

Press "UP" button , which

will be confirmed by a short

voltage supply to the

W1 or W2 output.

Press "UP" button , which

will be confirmed by a short

voltage supply to the

W1 or W2 output.

The transmitter has been added.