3M 710 사용 설명서 - 페이지 15

{카테고리_이름} 3M 710에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M 710 20 페이지. Splicing rig
3M 710에 대해서도 마찬가지입니다: 브로셔 및 사양 (4 페이지), 사양 (4 페이지)

8.0 3M

710 Splicing Rig Blade Assembly Replacement

™

 CAUTION: Use extreme care when handling old or new blades as even used blades are very sharp.

8.1 With the "T" bar in the up position, use the 3mm hex

wrench to remove the four (4) screws on the handle

side of the splicing rig head.

8.2 Open the "T" bar and use the 3mm hex wrench to

loosen (but do not remove) the two (2) screws on the

faceplate of the splicing rig head.

8.3 Using the middle fingers of both hands, push and

hold the blade guard down. Keeping fingers away

from the blade tips, slide the blade assembly forward

by using thumbs to push metal ends of the blade

assembly forward.

8.4 Place the new cutter blade into the pocket of the

metal blade holder tool so the flat sides of the

individual blades are flush with the surface of the

metal blade holder tool.

78-815-304--E