ALUZ A8-ZIZA-TAPE 설치 지침 매뉴얼 - 페이지 7

{카테고리_이름} ALUZ A8-ZIZA-TAPE에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ALUZ A8-ZIZA-TAPE 11 페이지. Led tape
ALUZ A8-ZIZA-TAPE에 대해서도 마찬가지입니다: 매뉴얼 (14 페이지)

ZIZA

Tape

A8-ZIZA-TAPE

Measure area where luminaire will be installed. Use a laser line to create

a reference line along installation area, ensuring consistent alignment of

mounting clips. Mark location where each mounting clip will be installed

along reference line.

Unroll lightstrip from reel using a wire puller stand and cut to size as needed.

Note: Include both sets of solder pads if soldering connectors. Refer to

Soldering Guide for details.

Remove adhesive backing from lightstrip and stick in place along chalk

line, ensuring lightstrip is securely mounted and free of twists, tangles,

creases, or bumps.

Note: Refer to Application Guidelines to ensure correct installation.

Lightstrip

Remove adhesive backing

Determine number of mounting clips needed. Refer to the Mounting Clips

page for details.

Note: The number of required mounting clips differs for dry and wet location

products. Verify number of mounting clips is appropriate for installation

environment before installing. Do not install luminaires with inadequate

number of mounting clips.

Lay mounting clips and pre-drill using proper drill bit for surface and screw size.

Recommendation: 8/32 x 1" screw.

Cut to size

Ensure lightstrip

is securely mounted

ALUZ

1170 North Red Gum Street, Anaheim, CA 92806

Phone: 800 921 2254 or 714 535 7900 | Fax: 714 535 7902 | [email protected] | aluz.lighting

Mounting Lightstrip (Dry Location Mounting Clips)

Screw mounting clips to surface.

Note: Ensure that no mounting clips are covering any LEDs along lightstrip.

If applicable, connect disconnects between luminaires or solder connectors

using the steps from Application Guidelines.

Perform a continuity test before connecting luminaire to power source.

Installation Instructions

9 / 1 / 2021 / Rev 0

Page 7 of 11