3M Digital Projector WX66 제품 안전 매뉴얼 - 페이지 12

{카테고리_이름} 3M Digital Projector WX66에 대한 제품 안전 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M Digital Projector WX66 17 페이지. Setup guide
3M Digital Projector WX66에 대해서도 마찬가지입니다: 설정 매뉴얼 (1 페이지), 빠른 시작 매뉴얼 (1 페이지), 사양 시트 (2 페이지)

페이지 인쇄

For maximum lamp life, do not strike or drop, improperly handle, or scratch the lamp glass.

Also, do not install an old or previously used lamp.

1. Remove lamp access door:

2. Retaining screws

All lamp module screws must be loosened. These screws are self-containing screws that

cannot be removed from the lamp module or access door.

3. Remove lamp module: Slowly pick up the lamp module by the handles. (4)

4. Insert lamp module : Carefully insert (4) the new lamp module. Ensure that it is fully seated.

Optional Lamp: 78-6969-9947-9 (DT00911) (Contact 3M Customer Service.)

While putting the interlocking parts of the lamp door and the projector together, slide

the lamp door back in place.

Reset the lamp operation hours. See "Reset Lamp Hours" for details.

(1) Screw

√ Note

Loosen the screw (marked by arrow)

then slide and lift the lamp door to the side to remove it.

: Use a screwdriver to unscrew the lamp module retaining screws

(marked by arrow). (3)

√ Note

Tighten the lamp module retaining screws (3) to secure the lamp module

in place.

Then firmly fasten the screw of the lamp door.

(2)

√ Note

(2) Lamp access door

3M™ Digital Projector WX66 Product Safety Guide

of the lamp door and

(1)

(2)

(1)

(3) Screws

(4) Handle