3M Digital Projector WX66 Product Safety Manual - Page 12

Browse online or download pdf Product Safety Manual for Projector 3M Digital Projector WX66. 3M Digital Projector WX66 17 pages. Setup guide
Also for 3M Digital Projector WX66: Setup Manual (1 pages), Quick Start Manual (1 pages), Specification Sheet (2 pages)

Print Page

3M Digital Projector WX66 Product Safety Manual

For maximum lamp life, do not strike or drop, improperly handle, or scratch the lamp glass.

Also, do not install an old or previously used lamp.

1. Remove lamp access door:

2. Retaining screws

All lamp module screws must be loosened. These screws are self-containing screws that

cannot be removed from the lamp module or access door.

3. Remove lamp module: Slowly pick up the lamp module by the handles. (4)

4. Insert lamp module : Carefully insert (4) the new lamp module. Ensure that it is fully seated.

Optional Lamp: 78-6969-9947-9 (DT00911) (Contact 3M Customer Service.)

While putting the interlocking parts of the lamp door and the projector together, slide

the lamp door back in place.

Reset the lamp operation hours. See "Reset Lamp Hours" for details.

(1) Screw

√ Note

Loosen the screw (marked by arrow)

then slide and lift the lamp door to the side to remove it.

: Use a screwdriver to unscrew the lamp module retaining screws

(marked by arrow). (3)

√ Note

Tighten the lamp module retaining screws (3) to secure the lamp module

in place.

Then firmly fasten the screw of the lamp door.

(2)

√ Note

(2) Lamp access door

3M™ Digital Projector WX66 Product Safety Guide

of the lamp door and

(1)

(2)

(1)

(3) Screws

(4) Handle