DLSIN DLA012NAS 사용자 빠른 설명서 - 페이지 7

{카테고리_이름} DLSIN DLA012NAS에 대한 사용자 빠른 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DLSIN DLA012NAS 18 페이지. 3.5” sata hdd

By default the service is set to Disabled meaning it will always try to connect automatically. If

you would prefer to only connect manually, change the drop down to Enable.

Note: To enable manual connection use the Connect button on the status page. See:

Status - PPPoE Address for manual connection instructions.

Network-DDNS

Enables you to assign an Internet Domain Name using a DDNS service for external access

to your enclosure over the Internet.

To setup, select Enable from the bullet menu.

If you are using a generic Dynamic DNS service, select Dyn from the service provider drop

down menu. Or if you are using No-IP as your service provider select NO-IP from the

DDNS service provider drop down menu.

Service Provider

Dyn

In the Host Name field, enter your Host Name which you've registered on the DDNS server.

Host Name

In the User Name field, enter the Username for the DDNS server.

User Name

In the password field, enter the Password for your DDNS server.

Password

Click the apply button.

Note: It may take up to an hour for the DDNS server to refresh and direct to the Enclosure.

For further assistance please contact your DDNS service provider.

UPnP Port Mapping (Universal plug and play)

Enables the enclosure to automatically find and communicate with your router and open

any ports required for network communication.

Place a bullet under Enable or Disable next to UPnP Port Mapping depending on your

preference.

UPNP Port Mapping

Note: Once you have click enabled the enclosure will automatically attempt to update the

router which could take several seconds. If you have chosen to enable UPnP

please ensure UPnP has also been enabled on your router. For further assistance

please contact your network administrator.

ENABLE

DISABLE