DLSIN DLA012NAS 사용자 빠른 설명서 - 페이지 9

{카테고리_이름} DLSIN DLA012NAS에 대한 사용자 빠른 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DLSIN DLA012NAS 18 페이지. 3.5” sata hdd

To Create a new RAID array click the RAID System Manage - RAID Link from the

Main menu.

Select your desired RAID mode from the RAID mode drop down menu and click the Main

menu.

RAID Mode

WARNING!: All drive data will be lost upon deleting the RAID array. A message will appear

warning that all written data will be lost. Click the OK button if you wish to

continue.

The page at 192.168.100.47 says:

This will format the hard disk and erase all data on this

disk.

Are you sure?

Upon creation of the new RAID array the S.M.A.R.T table for available drives will be

displayed.

Displays the current RAID array and the S.M.A.R.T status.

RAID Status

RAID 1

Create

Delete

Cancel

RAID 1 / Normal

Disk Information

Displays the model and capacity of each attached hard drive.

SATA0: ST3000DM001-CH166 / 279GB

Disk Information

SATA1: ST3000DM001-CH166 / 279GB

System Manage-Firmware Update

Access the Enclosure web GUI and select System Manage --Firmware from the main menu

Click the browse button, a Windows Explorer window will appear, locate and select the

firmware download in the location it was saved, and click the Open button.

The firmware upgrade will install.

WARNING! During the firmware upgrade do not turn off the enclosure or attempt to make

any configuration changes until the update is completed.

Once the upgrade has completed the enclosure will automatically reboot.

Note: Update may take several minutes. The below progress indicator will appear providing

a countdown to system reboot.