3M Digital Projector X75 제품 안전 매뉴얼 - 페이지 12

{카테고리_이름} 3M Digital Projector X75에 대한 제품 안전 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M Digital Projector X75 14 페이지. Safety guide
3M Digital Projector X75에 대해서도 마찬가지입니다: 브로셔 및 사양 (4 페이지), 빠른 시작 매뉴얼 (4 페이지), 빠른 시작 매뉴얼 (4 페이지), 사양 (2 페이지)

페이지 인쇄

For maximum lamp life, do not strike or drop, improperly handle, or scratch the lamp glass.

Also, do not install an old or previously used lamp.

1. Remove lamp access door: The lamp access door is located on the bottom of the machine.

Please unhook the claws of the lamp door (1), and remove the lamp door.

2. Retaining screws: Use a screwdriver to unscrew the lamp module retaining screws. (3)

All lamp module screws must be loosened. These screws are self-containing screws that

cannot be removed from the lamp module or access door.

3. Remove lamp module: Slowly pick up the lamp module by the handles. (4)

4. Insert lamp module: Carefully insert (4) the new lamp module. Ensure that it is fully seated.

Tighten the lamp module retaining screws (3) to secure the lamp module in place.

Optional Lamp: 78-6969-9797-8 (Contact 3M customer Service.)

Insert the hinge tabs on the bottom of the lamp access door, then

claws (1) to ﬁx the lamp door.

Reset the lamp operation hours. See "Reset Lamp Hours" for details.

(2) Lamp access door

(1) Claws

√ Note

(3) Screws

3M™ Multimedia Projector X75 Product Safety Guide

(2)

push the center point of two

(4) Handles