AERMEC ANK 설치 매뉴얼 - 페이지 4

{카테고리_이름} AERMEC ANK에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AERMEC ANK 14 페이지.

This heat pump is shipped in one package, completely

assembled and wired. The indoor controller is shipped in a separate

carton when ordered.

1. Check the heat pump rating plate to confirm specifications

are as ordered.

2. Upon receipt of equipment, carefully inspect it for possible

shipping damage. Take special care to examine the unit

inside the carton if the carton is damaged.

If damage is found, it should be noted on the carrier's freight bill.

Damage claims should be filed with the carrier immediately.

Claims of shortages should be filed with the seller within 5 days.

NOTE: If any damages are discovered and reported to the carrier,

do not install the unit because your claim may be denied.

2.1 HYDRONIC CONNECTIONS

Water / glycol piping must be connected by a licensed, or certified

technician using established procedures.

IMPORTANT:



Connecting water lines must be clean, properly sized

(minimum 1 ¼ inch). Reducing fitting shall not be used



Use care with the water / glycol lines during the installation

process. If pex is used it can be cut by sharp objects.



Do not remove the caps from the lines or system connection

points until connections are ready to be completed.

1. Route the supply and return lines from the fittings on the

indoor manifold or tank to the fittings on the heat pump. Run

the lines in as direct a path as possible avoiding unnecessary

turns and bends.

2. Ensure that both lines are insulated over the entire

exposed length and that both supply and return lines are not

in direct contact with floors, walls, duct work, floor joists, or

other piping.

3. Flush the lines out with water

4.Pack insulating material around water/glycol lines where they

penetrate the structure to protect the lines and to minimize

vibration transmission.

5. Connect the supply and return lines, and tighten using two

wrenches

NOTE: Always use two wrenches when tightening any fittings.

2 INSTALLATION INSTRUCTIONS

ANK 030‐045‐050 H‐HP

Air vent

ANK 030‐045‐050 HA

Air vent