Fleck 5600 Econominder 설치 매뉴얼 - 페이지 7
{카테고리_이름} Fleck 5600 Econominder에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fleck 5600 Econominder 11 페이지.
Fleck 5600 Econominder에 대해서도 마찬가지입니다: 소유자 매뉴얼 (8 페이지), 설치 지침 매뉴얼 (19 페이지)
페이지 인쇄
3) Before filling the tank, place a piece of painter's
tape over the top of the riser tube to prevent
resin from dropping down inside as shown in
Figure 7-a. i avoid using duct tape which
leaves behind unwanted residue
3 › I n s ta l l I n G t H e F l e C k 5 6 0 0 Va lV e
Using caution not to lift the riser tube,
1)
remove the filling funnel and tape.
using the included silicone lubricant packet, lubri-
cate the inner and outer o-rings on the bottom of
the Fleck 5600 Meter Valve as shown in Figures
7-C and 7-D
Help: 888-426-5001
4) Place the included filling funnel over the top of
the tank as shown in
fill the tank. If your softener system came with
gravel
pour in the included resin media afterwards
F I G u R e 7- a
2) Next, install the t
mesh)
While
Valve as seen in Figure 7-E and then place the
valve onto the top of the tank, being sure that the
riser tube fits into the central o-ring on the valve,
as shown in Figure 7-F.
the tank.
on the valve or tank threading
s ta n d a R d
F I n e m e s H
F I G u R e 7- C
F I G u R e 7- d
QualityWaterForLess.com
Figure 7-B
, please pour this into the tank
op screen (standard or fine
to the bottom of the Fleck 5600 Meter
hand-tighten
do not use teflon tape or pipe dope
and prepare to
first
, then
F I G u R e 7- B
the valve to
F I G u R e 7- e
F I G u R e 7- F
PAGE 7