Etabeta electronics NT-16 사용 설명서 - 페이지 8
{카테고리_이름} Etabeta electronics NT-16에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Etabeta electronics NT-16 18 페이지.
페이지 인쇄Features - Front panel
1. Channel COMP/ limiter
1). This knob can adjust the threshold size of the pressure limiter. When the pressure limiter switch is
opened, the adjustment is effective.2). In button is to open and close the limiter.
2. Channel EQ/ Equalizer
1). Equalizer parameter knob
Up to down means: gain, frequency and Q value.
2). Parameter equalizer button
The shortcut keys of the parameter equalizer are: treble, medium treble, medium, bass and bass (from
top to bottom). After lighting the corresponding keys, match the three parameters on the left
Adjust the knob to adjust the EQ parameters,
Note: EQ adjustment is only effective when the EQ switch (ON key) is turned ON.
3. channel HPF/LPF(high-low pass filter)
1).(HPF) high pass knob/high pass switch
Adjust this knob to reduce the low frequency signal, HPF button is high frequency on and off.
2).(LPF) Low Pass Knob/Low Pass Switch
Adjust this knob to reduce the high frequency signal, LPF button is low pass frequency on and off.
The high-low pass filter can be treated as a frequency divider
4. Input channel GATE/ noise GATE
This knob can adjust the threshold size of the noise door. The IN button is to open and close the noise
door.
5. Input channel gain/audiovisual control knob
1). Gain control
Adjust this knob to increase or decrease the input signal level.
2). Audio and video control knob
Controls the proportion of signals sent from the current channel to the main output L channel and R
channel.
6. Channel signal routing and sending
1). The current channel signal is sent to the main output channel L and channel R ( just light up).2). The
current channel signal is sent to the marshalling output SUB1-2( just light it up).
7. Channel signal indicator light
1).PK peak indicator
This is used to indicate that the channel's signal is approaching distortion (restricted).
2).0 signal indicator light
The light is on, indicating that there is a signal input on this channel.
3).SIG signal indicator
The light is on, indicating that there is a signal input on this channel.
8. channel selection key/mute key/listening key
1).SEL channel selection key
The button lights up to indicate that a channel has been selected and that channel parameters can be
edited.
2).ON mute switch
Channel mute switch. When off, it means the channel is in mute state and you will not hear the signal of
the channel
3).PFL monitor switch
When this button is pressed, the signal will be output from the listener and the headset.
9. Passage pushers
This is used to control the level on the current channel (electric push).
10. Main output push
Used for adjusting the size of the hybrid main output level (electric push).
7