Dog trace d-mute small 사용자 설명서 - 페이지 6

{카테고리_이름} Dog trace d-mute small에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dog trace d-mute small 13 페이지. Electronic anti bark collar
Dog trace d-mute small에 대해서도 마찬가지입니다: 사용자 설명서 (19 페이지)

페이지 인쇄

Battery installation / replacement

Use a cross-head screwdriver to remove the screws from the cover of the unit. Insert the

battery (3V lithium CR2). Mind the correct polarity marked inside. You will hear a sound

signal indicating that the battery is installed properly. If no sound signal comes out,

remove the battery immediately. Check the polarity and try again. If the unit does not

respond after reinstallation, the battery may be ﬂ at or the unit faulty and it requires

professional repair.

Before the cover is replaced, make sure the sealing is properly inserted in the slot.

Tighten the screws adequately.

If you do not use the collar for a long time, remove the battery from the unit.

How it works

The system is activated automatically by dog barking, or howling. 6 modes of correction

and sensitivity of the system can be set easily. The correction is based on an audio signal

or a correction pulse, eventually on combination of both. The collar is easy to use,

compact and waterproof. It is suitable for all dog breeds and sizes. In standby mode,

the device is waiting for barking our howling. After the ﬁ rst bark, it emits an audio signal

or an audio signal along with a correction pulse – its intensity depends on a selected

mode. If your dog keeps barking, the device responds again in the same way.

The process can be repeated 5 times at the most and then it is stopped automatically.

15 seconds after, the system is switched back into standby mode and is ready to

respond to barking again.