Cytron SHIELD-ESP-WIFI 사용자 설명서 - 페이지 14

{카테고리_이름} Cytron SHIELD-ESP-WIFI에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cytron SHIELD-ESP-WIFI 17 페이지.

페이지 인쇄
Cytron SHIELD-ESP-WIFI 사용자 설명서
8.0​ ​ F IRMWARE​ ​ I NSTALLATION
ESP8266 3V3 GPIO Input and Output function has deprecated with preloaded AT firmware
on ESP-WROOM-02 module on ESPWiFi Shield. However, Cytron Technologies offers
customised AT firmware which adds the stated capability to the module, allowing user to
utilise the 3V3 GPIO fully in the applications. User can follow the guide below to install new
AT​ ​ f irmware​ ​ t o​ ​ t he​ ​ m odule.
Hardware​ ​ c onfiguration
1. Stack the shield onto Arduino compatible board. In this example, Arduino Uno is
used.
2. Place​ ​ b oth​ ​ m ini​ ​ j umpers​ ​ o n​ ​ U SB​ ​ s election.
3.
**IMPORTANT!!
reset at all times (Another alternative, upload an empty sketch to Arduino Uno before
stacking​ ​ t he​ ​ s hield​ ​ o nto​ ​ i t)
4. Slide​ ​ t he​ ​ s lide​ ​ s witch​ ​ t o​ ​ F LASH​ ​ m ode.
5. Connect​ ​ t he​ ​ w hole​ ​ b oard​ ​ ( Arduino​ ​ U no​ ​ + ​ ​ E SPWiFi​ ​ s hield)​ ​ t o​ ​ P C​ ​ v ia​ ​ U SB​ ​ c able.
6. Press ESP Reset button (with slide switch switched to FLASH mode) to enable
FLASH​ ​ m ode​ ​ o f​ ​ E SP-WROOM-02​ ​ m odule.
Created​ ​ b y​ ​ C ytron​ ​ T echnologies​ ​ S dn.​ ​ B hd.​ ​ – ​ ​ A ll​ ​ R ight​ ​ R eserved
Product​ ​ U ser's​ ​ M anual​ ​ – ​ ​ E SPWiFi​ ​ S hield​ ​ R ev2.0
Connect RST to GND using jumper wire to make sure the board
ROBOT​ ​ . ​ ​ H EAD​ ​ t o​ ​ T OE
14