Blueridge Digi-Touch DDN-SW1 설치 매뉴얼 - 페이지 5
{카테고리_이름} Blueridge Digi-Touch DDN-SW1에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Blueridge Digi-Touch DDN-SW1 13 페이지.
페이지 인쇄
B l u e
R i d g e
T e c h n o l o g i e s
Overview
The Digi-Touch Network consists of three parts:
1. Digi-Touch Device Network Link. (DDN-Link). The first module is a communication interface board,
the DDN-Link. The Link provides communication between a Blue Ridge Technologies Panel
Controller and the Digital Switch devices on a twisted pair network.
2. Digi-Touch Device Network Switch (DDN-SW). The second module is a Digital Switch, DDN-SW1
(single button) or DDN-SW2 (two button). Each button provides users on/off control of a lighting
group. Each contains an integral bi-color LED that illuminates red when the associated lighting
group is turned on and green when turned off.
3. Network wire.
Quick Install Summary
The summary below is followed by 2 sections containing details for each step.
Step1.
Physical Mounting and Setting Dip Switches on the Switch Modules (DDN-SW1 and DDN-SW2).
Switches are physically mounted and addressed by dip switches. A look-up table is provided for
binary dip switch settings equivalent to lighting Group decimal numbers. See section entitled,
"Physical Dimensions and Dip Switch Settings" for details.
Step2.
Network the switches for communications and power. Make all connections before applying power.
Daisy chain the switches and power supplies with a 2-pair, twisted wire daisy chain. Use 18 AWG (for
power) and twisted pair 22 AWG (for signal) or better. Use Belden 1502P or equivalent. See section,
"Network the Switches for Communications and power" for details.
w w w. b r t i n t. c o m
Blue Ridge Technologies is a Trademark of Blue Ridge Technologies
© 2010 Blue Ridge Technologies International, LLC All Rights Reserved.
Digi-Touch
Installation Guide
8 0 0 - 2 4 1 - 9 1 7 3
page 5
Digi-Touch_IG.pdf
062310