Blueridge Digi-Touch DDN-SW1 설치 매뉴얼 - 페이지 7

{카테고리_이름} Blueridge Digi-Touch DDN-SW1에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Blueridge Digi-Touch DDN-SW1 13 페이지.

페이지 인쇄

B l u e

R i d g e

T e c h n o l o g i e s

Installation Steps

Step 1 - Physical Dimensions & Dip Switch Settings (DDN-SW)

a. Ensure proper size gang box and Decora plate for DDN-SW2.

b. If exact settings per each location have not been pre-set, set the correct dip switch

address on each module (see look-up table, Appendix A). It is helpful to use a work-

sheet to layout all the switch numbers for each panel before setting addresses on the

switches.

c. For DDN-SW2, when the dip switch is set for the upper button, the next lighting group

is automatically assigned to the lower button. Thus, the physical dip switch number

for the next module will typically "skip 1" as the modules are addressed along the

network. Ie, 1,3,5.... or 2,4,6....

d. Set the address using the dip switches under the Decora style plate. It is not neces-

sary to remove the entire switch. Use the Appendix A table to get the binary dipswitch

setting for the decimal lighting group number

e. See example below for DDN-SW (2-button).

(closest to dip switch) button controls panel group 5 and lower button controls group

6. The "group" refers to group assignments made in the Blue Ridge Technologies

panel via Lighting Panel Programmer's Kit (LPPK).

Dip Switch Value

Dip Switch Number

Dip Switch Detail

If you are also responsible for programming the lighting panels, see section entitled

"LPPK Setup for Blue Ridge Technologies Digi-Touch Switches", Appendix B in this

publication. For each DDN-SW2, both upper and lower button numbers must be

entered in LPPK.

w w w. b r t i n t. c o m

Blue Ridge Technologies is a Trademark of Blue Ridge Technologies

Dip switch

(1)

(2)

(4)

(8)

(16)

(32)

(64)

(128)

OFF

Installation Guide

is "5" in binary. Thus, upper

Step 1-e

(Front View)

DDN-SW

8 0 0 - 2 4 1 - 9 1 7 3

Digi-Touch

DDN-SW2

LEDs

Upper Push-Button

is assigned 5 per dip

switch setting

Lower Push-Button is

assigned 6 by default.

(dip setting plus 1 = 6)

Digi-Touch_IG.pdf

1.50"

page 7

062310