Ambient Weather WS-09 사용자 설명서 - 페이지 4

{카테고리_이름} Ambient Weather WS-09에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ambient Weather WS-09 15 페이지. 8-channel wireless refrigerator/freezer thermometer

페이지 인쇄

DOWN

---

5. Insert two AAA batteries.

6. After inserting the batteries, the remote sensor LED indicator will light for 4 seconds, and

then flash once per 60 seconds thereafter. Each time it flashes, the sensor is transmitting data.

7. Verify the correct channel number (CH) and temperature units of measure (°F vs. °C) are on

the display, as shown in Figure 3.

temperature

(1)

(2) temperature units (

(3) channel number

8. Close the battery door. Make sure the gasket (around the battery compartment) is properly

seated in its trace prior to closing the door. Tighten the set screw.

2.2 Display Console Set Up

1. Move the remote probe thermometer(s) about 5 to 10' away from the display console (if the

sensor is too close, it may not be received by the display console). If you have more than one

probe thermometer, make sure they are all powered up and transmitting on different channels.

2. Remove the battery door on the back of the display, as shown in Figure 4. Insert four AAA

Version 1.0

DIP SWITCH

DOWN

---

Table 1

Figure 3

°F vs. °C)

FUNCTION

---

Channel 1 (refrigerator)

---

Channel 2 (freezer)

---

Channel 3 (optional)

---

Channel 4 (optional)

---

Channel 5 (optional)

---

Channel 6 (optional)

---

Channel 7 (optional)

---

Channel 8 (optional)

DOWN

°F

°C

Page 4