Floe VSD 5000 Assembly Instructions Manual - Page 7

Browse online or download pdf Assembly Instructions Manual for Boating Equipment Floe VSD 5000. Floe VSD 5000 8 pages. Pontoon guide-in/bunk
Also for Floe VSD 5000: Assembly Instruction (4 pages), Assembly Instruction Manual (12 pages), Assembly Instructions Manual (8 pages), Assembly Instructions Manual (12 pages)

Print Page
Floe VSD 5000 Assembly Instructions Manual
FOLLOW THESE GUIDELINES FOR USING AND LOCATING THE PONTOON BUNKS (FIGURE 2.4).
-THE WIDTH OF THE BUNKS SHOULD KEEP THE PONTOONS OFF THE CRADLE BEAMS.
-THE BUNKS SHOULD BE KEPT AS LOW AS POSSIBLE (NOT QUITE TOUCHING THE CLAMP).
-TO PLACE BUNKS, FIND CENTER BETWEEN PONTOONS AND CENTER OF THE BOAT FROM PONTOONS
AND TRANSLATE MEASUREMENT TO CRADLE BEAM TO DETERMINE CENTER OF EACH PAIR OF BUNKS.
-THE REAR OF A 21' PONTOON BOAT SHOULD OVERHAND PAST THE LIFT BY 3 FEET. FOR EVERY
ADDITIONAL FOOT IN LENGTH OF THE BOAT, IT SHOULD OVERHANG BY AN ADDITIONAL 6 INCHES
BEYOND THE REAR OF THE LIFT. THESE ARE GENERAL GUIDELINES THAT CAN BE ADJUSTED FOR AN
INDIVIDUAL'S CIRCUMSTANCES.
-ONCE BUNKS ARE IN THEIR FINAL LOCATION, TORQUE 3/8" NUTS ON CRADLE CLAMPS TO 35 FT-LBS
AND ½" NUTS ON CRADLE CLAMPS TO 70 FT-LBS (FIGURE 2.4).
FIGURE 2.4
FIGURE 2.4
SHEET 7 OF 8