Akytec PD111 User Manual - Page 8

Browse online or download pdf User Manual for Transmitter Akytec PD111. Akytec PD111 13 pages. Pressure transmitter for general industrial application

Print Page

Connector mounting

5. Connector mounting

–

Strip approx. 35 mm of the cable and remove approx. 5 mm insulation from each wire

end.

–

Loosen the screw 1.

–

Lever the terminal holder 5 out of the enclosure 2 using the mounting hole on the seal

–

Unscrew the cable fitting 4 and take out the cable seal 3.

–

Lead the cable through the cable fitting 4 and the cable seal 3 in the enclosure 2.

Inproper mounting.

►

NOTICE

Enclosure seal can become damaged.

Do not push the terminal holder 5 out using the screw hole or the cable fitting 4.

–

Unscrew the cable fitting 4 and take out the cable seal 3.

–

Lead the cable through the cable fitting 4 and the cable seal 3 in the enclosure 2.

–

Connect the cable ends in accordance with the wiring diagram (Fig. 4.1).

–

Loosen the screw terminals of the terminal holder 5, connect the stripped wire ends in

accordance with the wiring diagram (Fig. 4.1) and screw the screw terminals in tight.

–

Put the terminal holder 5 and snap the connector seal 6 in the enclosure 2.

–

When screwing the cable fitting 4, make sure the cable fitting 4 with the cable seal

are assembled correctly and the cable seal 3 is not damaged.

–

Plug the socket (2+5+6) to the contacts 7.

–

Tighten the screw 1.

akYtec GmbH · Vahrenwalder Str. 269 A · 30179 Hannover · Germany · Tel.: +49 (0) 511 16 59 672-0 · www.akytec.de

Fig. 5.1 Angular connector according to EN 175301-803