Draper FlexShade NEXD Instructions Installation & Operation - Page 4

Browse online or download pdf Instructions Installation & Operation for Indoor Furnishing Draper FlexShade NEXD. Draper FlexShade NEXD 10 pages. Clutch-operated small and large hardware
Also for Draper FlexShade NEXD: Installation & Operation Instructions (6 pages), Instructions Installation & Operation (8 pages), Instructions Manual (8 pages), Instructions Installation & Operation (8 pages), Instructions Manual (12 pages)

Draper FlexShade NEXD Instructions Installation & Operation
Bottom-Up FlexShade
Small and Large Hardware
Section 3 - Converting Between Left and Right
Wall Mounting Configurations
1. Remove screws and Wall Mounting Bracket
from reverse side of endcap.
2. Insert Wall Mounting Bracket into slots
on other side of endcap, and use screws
to reattach Wall Mounting Bracket to endcap.

Section 4 - Spring Assist Idler

Caution: Do not allow shade roller to become exposed by running shade fabric too far down. Use stop balls provided in
hardware packet by Draper
to set up and down travel limits. Stop balls by others may be too small, and become lodged
®
in clutch mechanism.
1.
Remove the safety screw and slide from the top
idler endcap. Retain these pieces for later.
1.
3.
Swing the idler end into place, then slide the idler
end spear into the receiver. It may be necessary
to compress the spring-
loaded spear.
Figure 4-C
Caution: The retaining clip must be installed around the idler end shaft
as shown to prevent the roller assembly from moving left or right during
operation, and to ensure that the spring-loaded shaft does not retract
into the mechanism in case of a bearing failure.
NEXD,
®
Figure 3
(Standard)
Figure 4-A
2.
Slide
(RETAIN
FOR LATER)
Safety Screw
(RETAIN FOR LATER)
Note: Retainer Clip
has extrusion to fit
into slots on shaft.
1.
2.
Install roller assembly tube
onto clutch.
!
Tube indentation
must be aligned
with the FLAT side
of the clutch sprocket.
4.
Replace slide and safety screw. Place into groove
at an angle, slide up, and ensure the bottom of the
slide is hooked into the Receiver.
1.
Figure 4-D
Slide
Safety Screw
(RETAIN FOR LATER)
page 4 of 10
2.
Please Note: If shade fabric is
uneven, see "Field Adjustments"
on page 2.
Figure 4-B
2.