Draper FlexShade NEXD Instructions Installation & Operation - Page 5
Browse online or download pdf Instructions Installation & Operation for Indoor Furnishing Draper FlexShade NEXD. Draper FlexShade NEXD 10 pages. Clutch-operated small and large hardware
Also for Draper FlexShade NEXD: Installation & Operation Instructions (6 pages), Instructions Installation & Operation (8 pages), Instructions Manual (8 pages), Instructions Installation & Operation (8 pages), Instructions Manual (12 pages)
Bottom-Up FlexShade
Small and Large Hardware
Section 5 - Pre-tensioning Bottom Roller
Please Note: The fabric retraction device must be pre-tensioned to 3-5 revolutions.
Caution: NEVER ROTATE THE SPEAR IN THE OPPOSITE DIRECTION indicated by the arrows. If this happens, the springs MUST BE REPLACED.
Caution: DO NOT pre-tension the spring beyond 5 revolutions. Adding rotations WILL NOT increase the retraction spring force on the assembly. The mechanism
is rated for a maximum of 25 revolutions throughout the operating height of the shade. Up to 20 revolutions may be required for operation of the unit, plus a
maximum of 5 pre-rotations. Operating the fabric retraction device beyond 25 revolutions may cause the device to fail, requiring replacement.
Figure 5-A
Figure 5-B
Section 6 - Hem Bar
1. Remove one of the endcaps from the fabric hem bar.
2. Remove fabric retainer from hem bar and insert it into
the fabric hem.
3. Attach the hem bar assembly to the fabric panel by
sliding it over the fabric and retainer, then re-attach the
hem bar endcap.
Caution: Do NOT remove the draw cable from the hem
bar assembly during installation. Doing so may require
that the hem bar assembly be disassembled to
re-install the cable.
NEXD,
®
1. Orient the triangular shaped arrow on the end of the device to point UP
are zero pre-rotations on the device.
2. Holding the roller in this position, rotate spear counter-clockwise
approximately 1/4-turn. Restrain the spear and allow it to slowly unwind clockwise until it stops.
Caution: Allowing the spear to unwind rapidly can damage the mechanism.
3. Ensure that the fabric panel is wound tightly around the roller assembly.
4. Orient the hem bar and the triangular shaped arrow on the end of the fabric retraction device so that
the arrow points down toward the ground
Please Note: The number of rotations required can be found on the order label.
5. Hold the spear with pliers in this position, and rotate the roller
clockwise
(as indicated by the directional arrow)
"click" as the spring assist locks.
6. Hold roller with arrow pointing down, and use pliers to rotate the
spear in a counter-clockwise direction
"lock" at each revolution by rotating the spear just beyond one
full revolution, then, allowing it to slowly unwind until it stops at
the point where the triangular shaped arrow is again pointing
downward. Repeat this until the mechanism has 3-5 pre-rotations.
Please Note: The device must remain locked until the final step
. Rotating the fabric roller as though
draw cables are attached to roller)
the shade is being raised will unlock the device. The installer should
ensure that the hem bar cannot move around the fabric roller if the
roller is unlocked before the installation is complete.
WARNING: DO NOT OPEN. ASSEMBLY CONTAINS HIGHLY
STRESSED SPRINGS. UNIT IS NOT REPAIRABLE.
Scan this QR Code with
your smartphone to view
our online video,
or click HERE.
Figure 6
(Fig. 5-A)
(as indicated by the directional arrow)
.
(Fig. 5-B)
. There will be a slight
. The rotation will
(Fig. 5-C)
(when
page 5 of 10
. This ensures there
Figure 5-C