Anden A200V1 Installation And Operating Instructions Manual - Page 5

Browse online or download pdf Installation And Operating Instructions Manual for Dehumidifier Anden A200V1. Anden A200V1 12 pages.

Print Page

HANGING

The recommended method for hanging the dehumidifier is to use the eye bolts and hardware included in the parts bag. See FIGURE 7. Assemble the

four eye bolts to the mounting foot brackets as shown in FIGURE 8, and suspend using cable, chain, strapping or other support methods. NOTE: The

chain, cable or strapping must have a 200 lb. working load minimum, and each eye bolt must be used to suspend the dehumidifier.

The dehumidifier can be suspended using 1/4"-20 threaded rod as shown in FIGURE 9. IMPORTANT: Place the provided nuts and washers in the

same location as shown in Figure 8 when suspending with threaded rod.

The dehumidifier must be level for proper draining. Adjust the length of the chain, cable, threaded rod, etc., to level in all directions.

FIGURE 7 – HANGING UNIT

WITH CHAIN AND EYE BOLTS

1/4"–20 UNC EYE BOLT

DRAIN INSTALLATION

The blower draws air through the dehumidifier putting the cabinet under negative pressure. As a result a P-trap is required for proper draining.

The drain outlet on the dehumidifier can be hard piped using a 3/4" PVC Slip x 1" MNPT right angle fitting and 3/4" nominal drain tubing. If flexible,

clear PVC tubing is preferred, the provided drain fitting with a right angle bend to a 3/4" hose barb fitting can be installed. NOTE: PTFE thread seal

tape is recommended for threaded connections and hand tighten only. If hard pipe is used, PVC primer and cement is recommended for the slip

fit connections. After installing the drain, pour enough water (about 2 pints) into the dehumidifier to prime the traps. Remove the air filter from the

dehumidifier to access the drain pan.

FIGURE 10 – PVC DRAIN TUBING

FIGURE 8 – HARDWARE FOR

SUSPENDING DEHUMIDIFIER

MOUNTING

FOOT BRACKET

90-2335

90-2339

1/8" PER FT

MIN

90-2331

FIGURE 9 – HANGING UNIT

WITH THREADED ROD

1/4"-20 EYE BOLT

OR 1/4"-20

THREADED ROD

1/4"–20 UNC THREADED ROD

RIVNUT

FLAT WASHER

1/4"-20 NUT

WITH INTEGRAL

WASHER

FIGURE 11 – FLEXIBLE DRAIN TUBING

CABLE TIE

UNISTRUT

90-2335

KEEP TOP OF LOOP

BELOW THE BOTTOM

OF THE DEHUMIDIFIER

FLEXIBLE 3/4"

DRAIN TUBING

90-2331