Anden A200V1 Installation And Operating Instructions Manual - Page 6

Browse online or download pdf Installation And Operating Instructions Manual for Dehumidifier Anden A200V1. Anden A200V1 12 pages.

Print Page

If using the alternate drain fitting, follow the steps below to remove the

existing drain and install the alternate.

1. Remove the side panel adjacent to the inlet duct. See FIGURE 12.

2. Remove the nut and O-ring from the existing drain and pull out

existing drain.

3. Remove the nut from the alternate 90° drain fitting with hose barb

connection and insert the new fitting into the drain. NOTE: Use

plumber's putty between the drain and water side of the drain pan.

4. Install the nut and hand-tighten.

5. Pour a small amount of water in the drain to verify the seal between

the drain fitting and drain pan.

POWER WIRING

ELECTRICAL SHOCK HAZARD: High voltage may cause serious injury or death from electrical shock. Disconnect and tag electrical service before

starting installation or field-service. Leave electrical service disconnected until installation or field-service is complete.

ELECTRICAL SHOCK HAZARD: An interrupted or broken ground may cause property damage, serious injury or death should an electrical fault

occur. The cabinet must be grounded in accordance with NEC ANSI/NFPA 70-2011 or local codes. In Canada, refer to Canadian Electrical Code

CSA C22.1.

FIRE HAZARD: Use of improper wire may cause serious injury, property damage or death due to fire. Do not use aluminum wire for electrical

service to the dehumidifier. Use only copper wire.

Use of an undersized circuit breaker may cause property damage and/or the need for mold remediation service. See Specifications for wire and

circuit breaker sizing.

The dehumidifier must be hard wired, and an electrical disconnect switch must be installed to comply with appropriate codes or ordinances.

United States Installations: Make all electrical connections in accordance with the current edition of the NEC ANSI/NFPA 70 and any local codes or

ordinances that may apply.

Canada Installations: Make all electrical connections in accordance with the current edition of the Canadian Electrical Code CSA C22.1 and any local

codes or ordinances that may apply.

TABLE 2 – ELECTRICAL SPECIFICATIONS FOR HARD WIRING

Voltage

Minimum Circuit Capacity

Maximum Fuse or Circuit Breaker Amps

Minimum Wire Size AWG

FIGURE 12

90-2328

WARNING

CAUTION

Model A200V1

230-240 VAC, 60 Hz, 1 phase

13 A

20 A

14 AWG

INLET DUCT AND FILTER

REMOVE THIS PANEL

Model A200V1

265-277 VAC, 60 Hz, 1 phase

18 A

30 A

12 AWG

15 A

25 A

14 AWG