Bosch Programme Table Installation And Operating Instructions Manual - Page 26

Print Page

Bosch Programme Table Installation And Operating Instructions Manual

Dimensions

Width x depth x height

Hose and cable lengths

Left-hand connection

approx. 1350

min.

500

max.

approx. 1400

900

Water connection

Water supply

* depends on the model

Weight

approx. 1400

To prevent leaks or water damage, you must observe the instructions in

this section.

If in doubt, have a technician connect the appliance.

The water supply and drain hoses can be routed to the left of right,

depending on installation conditions.

Do not use a used inlet hose. Only use the inlet hose supplied or one

which was purchased from an authorised specialist retailer.

Do not allow the water supply hose to be:

– kinked or squashed,

– altered or cut (strength no longer guaranteed).

Note the water pressure in the mains supply:

The water pressure should be between 50-900 kPa (0.5-9 bar) (at least

8 litres of water flow out per minute when the tap is turned on).

If the water pressure is higher, a pressure reducing valve must be fitted.

Connect the cold-water supply hose (blue union nut) to the cold water tap

with ¾" pipe (3/4" = 26,4 mm) thread.

Only tighten plastic screw connections by hand.

Do not remove the filter from the supply hose.

After connecting the water supply hose:

– Turn the tap on fully.

– Check the connections for leaks.

595 mm x 584 mm x 820 mm

85 kg

approx. 1000

Right-hand connection

approx.

760

approx. 950

Dimensions in mm

min.

500

max.

900