Cookson FCA Instruction Manual - Page 10

Browse online or download pdf Instruction Manual for Gate Opener Cookson FCA. Cookson FCA 17 pages. M100 firegard chain; m100 firegard crank

Print Page

TERMINAL CONNECTIONS

Disconnect power supply before servicing.

WARNING

TB1

Input power 115VAC*, Not Supervised

TB2

1 (

)

2 (

)

Input 24VDC/VAC

Use Power Limited source

only

Not Supervised

*Note. 4

*Note:

1. Terminal 3&4

Building fire alarm panel (FACP) needs to provide dry contact (N/C) connection with minimum capacity of 24VDC and 0.5 amp.

Terminal 4

When connecting more than one wire/connector to the terminal, must use enclosed Part # CDA-FH600-WHF02. See page 13 for

illustration.

2. Terminal 6&7

This connection provides 24VDC, 1A power with 18AWG wire for maximum of 20 ft. Upon alarm signal, this connection can be

used to provide power for warning devices. The warning power is provided for less than a minute. The wiring connections are

enclosed within conduit or equivalently protected against mechanical injury.

3. Terminal 8&9

These terminal connections will provide the status of this release device. When release device is in the standby mode, connection is

open (N/O). When release device have been activated or released, connection would be in closed (N/C) state.

4. See connection chart for power inputs. A regulated, power limited UL1481 Power Supply must be used for this terminal.

See Note. 4

Alarm Dry Contact (N/C)

Not Supervised *Note 1

Close button

Dry contact (N/C)

Alarm door close warning

24VDC, total 1A

Common, Not Supervised

*Note 2

Brake release status

(Dry contact)

24VAC/VDC, 2A Max.

Resistive load, Common,

Not Supervised

*Note 3

M100 FireGard

Chain & Crank

02/11