activTek AP3000 User Manual - Page 7

Browse online or download pdf User Manual for Air Cleaner activTek AP3000. activTek AP3000 12 pages. Portable whole home office system
Also for activTek AP3000: Manual (16 pages), User Manual (12 pages)

Print Page

GENERAL MAINTENANCE

CLEANING THE PURIFIER PLATE:

Remove the rear lint screen (see pages 8 - 9) . Carefully

remove the purifier plate from the card cage by grasping

the middle of the edge nearest to you, and slowly pull it

straight out .

If you are in an environment where there are fats, oils,

or grease, such as in a kitchen, start by cleaning with

denatured alcohol and a soft bristle brush . This will cut

the grease without leaving a residue .

For all applications - Clean with a mixture of one part

water and one part ammonia to remove contaminants .

Place the plate into a shallow dish, and pour enough of

the water/ammonia solution into the dish to just cover

plate . Allow the plate to soak for no more than 10 minutes .

CAUTION: Damage may result from soaking the purifier

plate in the ammonia solution longer than 10 minutes.

OPTIONAL PREFILTER

To Remove:

Rear Back Panel

follow steps 1 - 3,

pg. 8

Prefilter

follow steps 4 - 5

pg. 8

3 . (a) For first install,

(CONT .)

1 . Remove the two

(2) thumbscrews

securing the

top of the lint

screen .

lay Optional

Prefilter on filter .

(b) For replacing,

remove Optional

Prefilter and

replace with a

new one .

Remove plate and scrub with a soft bristle brush .

Rinse thoroughly . Let air-dry for 24 hours or use a

blow dryer to dry thoroughly.

The unit will display a REPLACE PLATE message if the

purification plate needs to be replaced .

CHANGING THE ACTIVEPURE (RCI) CELL:

The ActivePure (RCI) cell should be replaced every year if

used continuously, even if the unit does not display this

message . Replace every two (2) years if used less than

12 hours a day. To change the ActivePure (RCI) cell, follow

the instructions on pages 8 - 9 .

SEE PAGES 8 - 9 FOR REMOVAL AND INSTALLATION INSTRUCTIONS

* See next page for back cover removal instructions

4 . Replace

the rear

lint screen,

inserting

the bottom

of the lint

screen first .

Note: The bottom of the rear lint

screen is held into place by two

alignment guides (see inset) .

A P 3 0 0 0

2 . Remove the lint

screen by pulling

back the top,

then lifting up

and out .

5 . Secure the

top of the

lint screen by

replacing the

two (2) lint

screen holder

thumbscrews .