Jamr Technology B02T User Manual - Page 7

Browse online or download pdf User Manual for Blood Pressure Monitor Jamr Technology B02T. Jamr Technology B02T 17 pages.

Print Page

4. Using your Monitor for the First Time

4.1 Activating the pre-installed batteries

Battery Installation

Use only 1.5V "AAA" alkaline batteries with this device.

1. Press the hook on the bottom of the battery cover and lift the cover off in

the direction of the arrow.

2. Install 4 "AAA" size batteries so the + (positive) and (negative) polarities

match the polarities of the battery compartment, replace the battery

cover.Make sure that the battery cover is securely in position.

Battery replacement

Low Battery Indicator

1.When the Low Battery Indicator appears on the display, turn the monitor off

and remove all the batteries. Replace with 4 new batteries at the same time.

Long-life alkaline batteries are recommended.

2.To prevent the damage of monitor from leaked battery fluid, please take out

of battery if the monitor unused in a long time(generally more than 3 months).

If battery fluid should get in your eyes, immediately rinse with plenty of clean

water. Contact a physician immediately.

3. Attached battery is only for testing the function of the monitor, Long-life

alkaline batteries are recommended.

4. Dispose of the device, components and optional accessories according to

applicable local regulations. Unlawful disposal may cause environmental

pollution

5.Battery is dangerous stuff, do not mix it with other rubbish.

4.2. System Settings

After you load the battery or connect power for the monitor.

A. Setting the User:

Press the SET button and then you can set the A/B user by shifting the A/B

user button.

B.Setting the Year/Month&Date/Time/Volume:

Long press the SET button for more than 3s, and then you can start to set.

Setting the Year:

Initial year is 2019, when the year display is flashing, press the MEM button,

the year will increase by I year each, hold the MEM button and it will increase

continuously 1 by 1, until 2049, and then rollover to 2019, once the year SET

is OK, press SET button to confirm.

Setting Month/Date:

Initial Month/Date is 1/01, when the Month display is flashing, press the MEM

button, the month will increase by 1, press SET button to confirm, and do in the

same way to set the date. Press SET button to confirm.

Setting Time :

When the hour display is flashing, press the MEM button, the hour will

increase by 1, press SET button to confirm, and do in the same way to set

the minute. Press SET button to confirm.

Setting Volume:

When display with SP is flashing, press MEM button to switch volume 1,

volume 2, volume 3 or OFF. Press SET button to confirm.

C.Record Delete:

When you checking the memory data, long press MEM button to delete

existing user measurement data.

Note:

You can't delete all measurement record from the monitor storage at one

time, if you decide to delete the all record, please keep the record in another

way, in case you need it some days later. Take the battery out won't lead to a

record missing.

4.3. Cuff tube connection

Insert the cuff tube into the opening on the left side of the monitor indicated

by the drawing of a cuff.