Fujitsu PRIMERGY 10/40GbE User Manual - Page 9

Browse online or download pdf User Manual for Server Fujitsu PRIMERGY 10/40GbE. Fujitsu PRIMERGY 10/40GbE 23 pages. Connection blade 18/8+2

Print Page

2.5 Changing Switch Mode , IBP Mode and EHM

There are 3 modes for this product Switch mode, IBP mode and EHM. EHM is its default mode. Switch

mode works as normal Layer2 switch. EHM is basically the same as switch mode, but it prohibit the

forwarding between uplinks and STP configuration to prevent uplink Loop by some mistakes. IBP mode is

prepared for easy configuration so that a server administrator can configure it. Refer to other manuals to

know the detail of these mode

To change current mode, execute the following commands.

Change current mode to switch mode

# boot-system△mode△switch

# reset

Change current mode to IBP mode

# boot-system△mode△ibp

# reset

Change current mode to EHM

# boot-system△mode△ehm

# reset

You can check current mode with show system information command.

PRIMERGY 10/40GbE Connection Blade 18/8+2 User Guide

Page 9 / 23