Fujitsu PRIMERGY RX200 S6 Service Supplement Manual - Page 37

Browse online or download pdf Service Supplement Manual for Server Fujitsu PRIMERGY RX200 S6. Fujitsu PRIMERGY RX200 S6 50 pages.

Print Page
Fujitsu PRIMERGY RX200 S6 Service Supplement Manual
4.7

Replacing a riser card

There are three different riser cards:
– Riser card #1: PCIe x8, standard and low-profile expansion cards
– Riser card #2: PCIe x8, only low-profile expansion cards
– Riser card #3: PCIe x4, internal, only for (low-profile) RAID controllers
I
The following description applies to all variants of riser cards.
Removing the defective riser card
Ê Open the server as described in the
page
23.
Figure 16: Position of riser card holders 1-3
Ê If necessary, disconnect the cables from the relevant expansion card.
Ê Lift the required riser card holder upward and remove it.
Ê Remove the expansion card from the PCI slot of the riser card (description
see the Options Guide).
RX200 S6
2
1
Service Supplement
Replacement routines
section "Opening/closing the server" on
3
37