Chapter 5 Daily Care
This chapter describes how to clean the ScanSnap.
• Before you clean the ScanSnap, unplug the power cable from the power outlet to
WARNING
• To avoid injuries, do not place the internal parts (such as the Pad ASSY and pick roller)
• Do not use any aerosol sprays or alcohol based sprays to clean the ScanSnap. Dust
5.1 Cleaning Materials
Cleaning Materials
Cleaner F1
Cleaning wipe
Lint-free dry cloth
*1) It may take long before the cleaner vaporizes if a large quantity is used. When cleaning the ScanSnap
parts, dampen a cloth with modest quantities of the cleaner. In addition, wipe off the cleaner
completely with a soft lint-free cloth to leave no residue on the surface of the cleaned parts.
*2) Pre-moistened with Cleaner F1, Cleaning Wipes are used instead of moistened cloths.
*3) Any lint-free cloth can be used.
To purchase the cleaning material, contact the store where you purchased the ScanSnap or an authorized
FUJITSU scanner service provider.
5.2 Cleaning the ScanSnap Exterior
Clean the ScanSnap exterior with a cloth moistened with a small amount of neutral detergent or Cleaner
F1 (sold separately).
• Never use paint thinner or other organic solvents.
ATTENTION
• During the cleaning, prevent water or moisture from getting inside the ScanSnap.
prevent from fire or electric shock.
in areas where small children can reach.
blown up by strong air from the spray may enter the inside of the ScanSnap. This may
cause the ScanSnap to fail or malfunction. Sparks, caused by static electricity,
generated when blowing off dust and dirt from the outside of the ScanSnap may cause
a fire.
Parts No.
PA03950-0352
PA03950-0419
Commercially available. (*3)
Remarks
1 bottle (100 ml) (*1)
1 pack (24 sheets) (*2)
Cloth
Cleaner F1 or
neutral detergent
Paint thinner
ScanSnap S510M Getting Started
30
Print Page