Fujitsu MB91460 SERIES User Manual - Page 36

Browse online or download pdf User Manual for Motherboard Fujitsu MB91460 SERIES. Fujitsu MB91460 SERIES 45 pages. 32-bit microcontroller
Also for Fujitsu MB91460 SERIES: Getting Started (41 pages), Application Note (23 pages), Application Note (26 pages), Application Note (29 pages), Application Note (29 pages)

Print Page

2) If the programming software should generate a reset signal on RTS or DTR line, refer

to the following jumper list.

Jumper

JP88

(RTS-CTS)

JP87

(DTR/RTS)

JP80

(RST 0)

JP51

(DTR / DTRx)

JP53

(RST MCU)

3) The CPU Mode selection must be set to serial programming mode by setting DIP

switch S1 to (Off, On, Off, Off)

4) Start the 'FME-FR Programmer' and connect the UART0 to your serial PC

communication port. A straight cable connection has to be used.

5) Choose the microcontroller device ("MB91F467R") as device type and browse to the

mhx-file you want to program to the embedded flash memory of the microcontroller.

Press the button "Automatic Mode" to start programming.

6) Immediately reset the microcontroller.

FMEMCU-UG-910053-16

SK-91467R-176PMC User Guide

Chapter 5 Programming the internal Flash

Setting

Description

Closed

RTS and CTS of X2 are connected

Open

RTS and CTS of X2 are not connected

1-2

DTR signal (Pin 6 of X2) is used as reset source

2-3

RTS signal (Pin 7 of X2) is used as reset source

Closed

LIN-UART 0 (X2) connected to reset circuit

1-2

No negation for the DTR/RTS signal

2-3

DTR/RTS signal is negated

Closed

External reset generation is active

Table 5-2: Jumper Settings for reset signal

- 36 -