Fujitsu MB91460 SERIES Kullanıcı Kılavuzu - Sayfa 36
Anakart Fujitsu MB91460 SERIES için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Fujitsu MB91460 SERIES 45 sayfaları. 32-bit microcontroller
Ayrıca Fujitsu MB91460 SERIES için: Başlarken (41 sayfalar), Uygulama Notu (23 sayfalar), Uygulama Notu (26 sayfalar), Uygulama Notu (29 sayfalar), Uygulama Notu (29 sayfalar)
Sayfayı Yazdır
2) If the programming software should generate a reset signal on RTS or DTR line, refer
to the following jumper list.
Jumper
JP88
(RTS-CTS)
JP87
(DTR/RTS)
JP80
(RST 0)
JP51
(DTR / DTRx)
JP53
(RST MCU)
3) The CPU Mode selection must be set to serial programming mode by setting DIP
switch S1 to (Off, On, Off, Off)
4) Start the 'FME-FR Programmer' and connect the UART0 to your serial PC
communication port. A straight cable connection has to be used.
5) Choose the microcontroller device ("MB91F467R") as device type and browse to the
mhx-file you want to program to the embedded flash memory of the microcontroller.
Press the button "Automatic Mode" to start programming.
6) Immediately reset the microcontroller.
FMEMCU-UG-910053-16
SK-91467R-176PMC User Guide
Chapter 5 Programming the internal Flash
Setting
Description
Closed
RTS and CTS of X2 are connected
Open
RTS and CTS of X2 are not connected
1-2
DTR signal (Pin 6 of X2) is used as reset source
2-3
RTS signal (Pin 7 of X2) is used as reset source
Closed
LIN-UART 0 (X2) connected to reset circuit
1-2
No negation for the DTR/RTS signal
2-3
DTR/RTS signal is negated
Closed
External reset generation is active
Table 5-2: Jumper Settings for reset signal
- 36 -
© Fujitsu Microelectronics Europe GmbH