Fujitsu MB91460 SERIES Руководство пользователя - Страница 36

Просмотреть онлайн или скачать pdf Руководство пользователя для Материнская плата Fujitsu MB91460 SERIES. Fujitsu MB91460 SERIES 45 страниц. 32-bit microcontroller
Также для Fujitsu MB91460 SERIES: Начало работы (41 страниц), Примечание по применению (23 страниц), Примечание по применению (26 страниц), Примечание по применению (29 страниц), Примечание по применению (29 страниц)

2) If the programming software should generate a reset signal on RTS or DTR line, refer

to the following jumper list.

Jumper

JP88

(RTS-CTS)

JP87

(DTR/RTS)

JP80

(RST 0)

JP51

(DTR / DTRx)

JP53

(RST MCU)

3) The CPU Mode selection must be set to serial programming mode by setting DIP

switch S1 to (Off, On, Off, Off)

4) Start the 'FME-FR Programmer' and connect the UART0 to your serial PC

communication port. A straight cable connection has to be used.

5) Choose the microcontroller device ("MB91F467R") as device type and browse to the

mhx-file you want to program to the embedded flash memory of the microcontroller.

Press the button "Automatic Mode" to start programming.

6) Immediately reset the microcontroller.

FMEMCU-UG-910053-16

SK-91467R-176PMC User Guide

Chapter 5 Programming the internal Flash

Setting

Description

Closed

RTS and CTS of X2 are connected

Open

RTS and CTS of X2 are not connected

1-2

DTR signal (Pin 6 of X2) is used as reset source

2-3

RTS signal (Pin 7 of X2) is used as reset source

Closed

LIN-UART 0 (X2) connected to reset circuit

1-2

No negation for the DTR/RTS signal

2-3

DTR/RTS signal is negated

Closed

External reset generation is active

Table 5-2: Jumper Settings for reset signal

- 36 -