Dell EqualLogic PS Series Hardware Owner's Manual - Page 13

Browse online or download pdf Hardware Owner's Manual for Storage Dell EqualLogic PS Series. Dell EqualLogic PS Series 50 pages. Storage arrays
Also for Dell EqualLogic PS Series: Setting Up (2 pages), Hardware Owner's Manual (48 pages), Hardware Maintenance (46 pages)

Print Page

Dell EqualLogic PS Series Hardware Owner's Manual

PS6610 Hardware Owner's Manual

• Use telnet or SSH to connect to a functioning IP address assigned to a network interface on the

array. Do not connect to the group IP address.

• Use the null modem cable, shipped with the array, to connect the serial port on the active

control module (ACT LED is green) to a console or a computer running a terminal emulator.

Make sure the serial line characteristics are as follows:

• 9600 baud

• One STOP bit

• No parity

• 8 data bits

• No flow control

2. Log in to an account with read-write access, such as the grpadmin account.

3. Enter the

shutdown

Password:

Welcome to Group Manager

group1> shutdown

After entering the

shutdown

Do you really want to shutdown the system? (yes/no)

Halt at Fri Dec 12 09:43:44 EST 2014 -- please wait...

6932:0:logevent:12-Dec-2014 09:4-

3:44.400000:logevent.cc:238:WARNING::25.3.0: User has initiated a clean

halt restart.

Main power usage is 68.5702 watts

sbs_ship_mode: Ship Mode request sent to battery

PLEASE WAIT FOR SHIP MODE CONFIRMATION MESSAGE!!

Waiting for Ship Mode entry: 5 sec

Waiting for Ship Mode entry: 10 sec

Waiting for Ship Mode entry: 15 sec

Waiting for Ship Mode entry: 20 sec

Waiting for Ship Mode entry: 25 sec

Waiting for Ship Mode entry: 30 sec

Check peer controller completion

No peer responding, peer battery is off

Batteries are now in Ship Mode!

Placing array in standby mode. To exit standby mode press and hold a

standby switch on any controller in the array.

4. Switch off the enclosure power supplies.

If you are using a network connection, the session will be disconnected before the array is fully

Note:

shut down. Confirm that the ACT LED on each control module is off (not lit) before turning off power

to the array at the power supply.

command:

command, the system displays information similar to the following output:

1 Basic Storage Array Information