Dell PowerVault DR4100 Best Practices Manual - Page 33

Browse online or download pdf Best Practices Manual for Storage Dell PowerVault DR4100. Dell PowerVault DR4100 41 pages. Backup and recovery appliance
Also for Dell PowerVault DR4100: Getting Started Manual (10 pages), Manual (37 pages), Release Note (16 pages), Manual (12 pages), Manual (24 pages), Manual (23 pages), Qiuck Setup (1 pages), Manual (27 pages), Manual (25 pages)

Print Page

Dell PowerVault DR4100 Best Practices Manual

administrator@DR1 > network --route --add --network 172.20.21.2 --netmask 255.255.255.0

--gateway 172.20.21.1 --interface eth2

administrator@DR1 > network --route --add --network 172.20.23.2 --netmask 255.255.255.0

--gateway 172.20.23.1 --interface eth3

administrator@DR1 > network --show --routes

Destination

172.20.21.0

172.20.23.0

From either DR1 or DR2 verify network connectivity using the following command:

network -- ping -- destination <ip_address> --interface<eth0,eth1,ethN>

administrator@DR1 > network --ping --destination 172.20.23.2 --interface eth3 --tries 1

10. Assuming that DR1 and DR2 already had replication established, stop replication and update it to use the newly

configured interfaces using the commands below.

replication --stop --name <replication_container> --role <source|target>

replication --update --name <replication_container> --peer <target_ip_address> --replication_traffic

<source_ip_address> --role source

administrator@DR1 > replication --stop --name cv-replicated-maglib --role source

administrator@DR1 > replication --update --name cv-replicated-maglib --peer 172.20.21.2 --

replication_traffic 172.20.20.2 --role source

Note: If a replication pair does not already exist between DR1 and DR2, use the steps outlined in scenario 1 for

assigning replication to designated interfaces and to create a replication pair.

DR4100 Best Practice Guide | April 2014

Gateway

Mask

172.20.20.1

255.255.255.0 eth2

172.20.22.1

255.255.255.0 eth3

Example

Interface

Example