Dell PowerVault TL4000 Getting Started - Page 23

Browse online or download pdf Getting Started for Storage Dell PowerVault TL4000. Dell PowerVault TL4000 38 pages. Tape library
Also for Dell PowerVault TL4000: Release Notes (3 pages), Faq (26 pages), Quick Start Manual (7 pages), Software Manual (16 pages), Configuration Manual (22 pages), Important Information Manual (10 pages), User Manual Addendum (2 pages), Getting Started Manual (3 pages), Attachment Instructions (17 pages), Brochure (4 pages), User Manual (20 pages)

Print Page

Configuring Your Library

The library can be configured using the Operator Control Panel and/or the Web

User Interface. The recommended method for configuring your library is using the

Web User Interface.

To configure your library, you will be using the Operator Control Panel and/or the

Web User Interface. Static library network settings must be entered using the

Operator Control Panel before the library can be accessed remotely using the Web

User Interface. If your system is serviced by DHCP (Dynamic Host Configuration

Protocol) server, the network parameters will be automatically set. Once remote

access has been established, you can complete the configuration of your library.

Accessing the Configure Menu using the Operator Control

Panel

1. Press the UP button to display the Main menu.

2. Press the DOWN button to select Configure.

3. Press the SELECT button to display the Configure menu.

If you would like to use DHCP (Dynamic Host Configuration Protocol ) as your

library network setting, complete Steps 1, 2, 3, and 7. If you do not want to use

DHCP as your library network setting, complete Steps 1, 2, 4, 5, 6, and 7.

1. Press the DOWN button to highlight the Network menu.

2. Press the SELECT button to display the Network screen.

3. If you do not want to select DHCP as your library network setting, skip this

step and proceed to the next step. If you want to select DHCP as your library

network setting, complete the following steps:

a. Press the SELECT button to highlight the DHCP field.

b. Press the DOWN button to select ON.

c. Press the SELECT button to apply your selection.

d. Skip to Step 7.

4. Press the DOWN button to select IP Address.

a. Press the SELECT button to highlight the IP Address field.

b. Press the UP or DOWN button to select the digit(s) of your library's IP

Address.

c. Press the SELECT button to highlight the next digit(s) in your IP Address.

d. After entering the final digits, press the SELECT button to apply your

entries.

5. Press the DOWN button to select Netmask.

a. Press the SELECT button to highlight the Netmask field.

b. Press the UP or DOWN button to select the digit(s) in your library's

Netmask address.

c. Press the SELECT button to highlight the next digit(s) in your library's

Netmask address.

d. After entering the final digit(s) in your Netmask address, press the

SELECT button to apply your entries.

6. Press the DOWN button to select Gateway.

1-13

Installation