Dell PowerConnect B-RX4 Installation Manual - Page 3

Browse online or download pdf Installation Manual for Switch Dell PowerConnect B-RX4. Dell PowerConnect B-RX4 17 pages. Instant access point
Also for Dell PowerConnect B-RX4: Manual (10 pages)

Print Page

Figure 2

W-AP130 Series Access Point Rear

Reset Button

DC Power Socket

ENET 1

CONSOLE

ENET 0

Kensington Security Slot

Console Port

Use the console port to connect to a terminal for direct local management.

Ethernet Ports

W-AP130 Series access points are equipped with two 10/100/1000Base-T (RJ-45) auto-sensing, MDI/MDX wired-

network connectivity ports. These ports support IEEE 802.3at Power over Ethernet (PoE) compliance, accepting

56 VDC as a standard defined Powered Device (PD) from a Power Sourcing Equipment (PSE) such as a PoE

midspan injector, or network infrastructure that supports PoE.

NOTE: Use the ENET 0 port for uplink connections to a switch or router. The ENET 1 port does not provide wired connectivity.

DC Power Socket

If PoE is not available, an optional Dell power adapter kit (sold separately) can be used to power the

access point.

Reset Button

The reset button can be used to return the access point to factory default settings. To reset the access point:

1. Power off the W-IAP130 Series by removing the Ethernet cable (POE) or power adapter cable.

2. Press and hold the reset button using a small, narrow object, such as a paperclip.

3. Power-on the access point without releasing the reset button. The power LED will flash within 5 seconds.

4. Release the reset button.

Dell PowerConnect W-IAP130 Series Instant Access Point | Installation Guide