Dell PowerConnect B-RX4 설치 매뉴얼 - 페이지 3

{카테고리_이름} Dell PowerConnect B-RX4에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect B-RX4 17 페이지. Instant access point
Dell PowerConnect B-RX4에 대해서도 마찬가지입니다: 매뉴얼 (10 페이지)

페이지 인쇄

Figure 2

W-AP130 Series Access Point Rear

Reset Button

DC Power Socket

ENET 1

CONSOLE

ENET 0

Kensington Security Slot

Console Port

Use the console port to connect to a terminal for direct local management.

Ethernet Ports

W-AP130 Series access points are equipped with two 10/100/1000Base-T (RJ-45) auto-sensing, MDI/MDX wired-

network connectivity ports. These ports support IEEE 802.3at Power over Ethernet (PoE) compliance, accepting

56 VDC as a standard defined Powered Device (PD) from a Power Sourcing Equipment (PSE) such as a PoE

midspan injector, or network infrastructure that supports PoE.

NOTE: Use the ENET 0 port for uplink connections to a switch or router. The ENET 1 port does not provide wired connectivity.

DC Power Socket

If PoE is not available, an optional Dell power adapter kit (sold separately) can be used to power the

access point.

Reset Button

The reset button can be used to return the access point to factory default settings. To reset the access point:

1. Power off the W-IAP130 Series by removing the Ethernet cable (POE) or power adapter cable.

2. Press and hold the reset button using a small, narrow object, such as a paperclip.

3. Power-on the access point without releasing the reset button. The power LED will flash within 5 seconds.

4. Release the reset button.

Dell PowerConnect W-IAP130 Series Instant Access Point | Installation Guide