Dell PowerConnect B-RX4 Kurulum Kılavuzu - Sayfa 3
Anahtar Dell PowerConnect B-RX4 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Dell PowerConnect B-RX4 17 sayfaları. Instant access point
Ayrıca Dell PowerConnect B-RX4 için: Manuel (10 sayfalar)
Figure 2
W-AP130 Series Access Point Rear
Reset Button
DC Power Socket
ENET 1
CONSOLE
ENET 0
Kensington Security Slot
Console Port
Use the console port to connect to a terminal for direct local management.
Ethernet Ports
W-AP130 Series access points are equipped with two 10/100/1000Base-T (RJ-45) auto-sensing, MDI/MDX wired-
network connectivity ports. These ports support IEEE 802.3at Power over Ethernet (PoE) compliance, accepting
56 VDC as a standard defined Powered Device (PD) from a Power Sourcing Equipment (PSE) such as a PoE
midspan injector, or network infrastructure that supports PoE.
NOTE: Use the ENET 0 port for uplink connections to a switch or router. The ENET 1 port does not provide wired connectivity.
DC Power Socket
If PoE is not available, an optional Dell power adapter kit (sold separately) can be used to power the
access point.
Reset Button
The reset button can be used to return the access point to factory default settings. To reset the access point:
1. Power off the W-IAP130 Series by removing the Ethernet cable (POE) or power adapter cable.
2. Press and hold the reset button using a small, narrow object, such as a paperclip.
3. Power-on the access point without releasing the reset button. The power LED will flash within 5 seconds.
4. Release the reset button.
Dell PowerConnect W-IAP130 Series Instant Access Point | Installation Guide
3