Dell S4148-ON Configuration Manual - Page 12

Browse online or download pdf Configuration Manual for Switch Dell S4148-ON. Dell S4148-ON 19 pages. Dell emc sc series sans

Print Page

Configure Data Center Bridging (DCB) (optional)

To enable DCB mode on the switch, use the commands in this section.

Note: Complete the switch configuration steps in section 2 before configuring the switch for DCB mode.

Note: DCB switch configuration is applicable only for environments with DCB-capable SC Series arrays.

3.1

OS10# configure terminal

OS10(config)# no iscsi enable

OS10(config)# no iscsi session-monitoring enable

3.2

OS10# configure terminal

OS10(config)# interface range ethernet 1/1/1–1/1/54

OS10(conf-range-eth1/1/1-1/1/54)# no flowcontrol receive

OS10(conf-range-eth1/1/1-1/1/54)# no flowcontrol transmit

OS10(conf-range-eth1/1/1-1/1/54)# exit

OS10(config)#

3.3

OS10(config)# dcbx enable

3.4

Note: You must supply a VLAN ID. The valid range is 2-4093.

The following commands configure a single VLAN ID. If desired, multiple VLAN IDs can be created on the

switch and assigned to ports.

OS10(config)# interface vlan <vlan-id>

OS10(conf-if-vl-<vlan-id>)# mtu 9216

OS10(conf-if-vl-<vlan-id>)# no shutdown

OS10(conf-if-vl-<vlan-id>)# exit

12 Dell EMC Networking S4148-ON and S4128-ON Switch Configuration Guide for Dell EMC SC Series SANs | SCG3704