digico A-CONTROL8 Getting Started Manual - Page 12

Browse online or download pdf Getting Started Manual for Remote Control digico A-CONTROL8. digico A-CONTROL8 15 pages. For 4rea4

Print Page

5.2 4REA4 connection

Connect the A-CONTROL8 to a 4REA4 Network port using a CAT5 cable up to 100m

long.

Power up the A-CONTROL8 by plugging the external PSU into the DC In socket or

connecting using a CAT5 cable to a PoE+ switch. The port Lnk/Err indicator flashes at

a steady rate when the link is established. The unit Name and IP address are displayed

on the LCD Displays for easy identification of the unit. After a few seconds the A-

CONTROL8 will display the assignments and functions if any have been set for the

unit.



is not the same version as that in the 4REA4, then the 4REA4

will automatically update the A-Control firmware at power up.

For parallel connection of multiple A-Control Remote Controllers you can use a standard

Ethernet switch.



standard (25.5W at source) is required. Check that the overall

power rating is enough to provide for all IP Remote

Controllers you wish to connect (allow 25W per A-CONTROL8

unit).

A-Control8 Getting Started Guide

If the firmware in a connected A-Control Remote Controller

For PoE (Power over Ethernet), the PoE+ 802.3at

AP11452 Issue 1