Cisco 7931G - Unified IP Phone VoIP Administration Manual - Page 12

Browse online or download pdf Administration Manual for IP Phone Cisco 7931G - Unified IP Phone VoIP. Cisco 7931G - Unified IP Phone VoIP 17 pages. For cisco unified callmanager express 4.0
Also for Cisco 7931G - Unified IP Phone VoIP: User Manual (20 pages), Administration Manual (10 pages), Administration Manual (20 pages), Installation Instructions (4 pages), Manual (30 pages), Administration Manual (12 pages), Quick Reference (2 pages), Quick Reference Card (2 pages), User Manual (15 pages)

Print Page
Cisco 7931G - Unified IP Phone VoIP Administration Manual
Adding Phones to the Cisco Unified Communications Manager Database
Adding Phones with Auto-Registration
Note
Note
Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 6.1
2-12
Chapter 2
By enabling auto-registration before you begin installing phones, you can:
Add phones without first gathering MAC addresses from the phones.
•
Automatically add a Cisco Unified IP Phone to the Cisco Unified
•
Communications Manager database when you physically connect the phone
to your IP telephony network. During auto-registration, Cisco Unified
Communications Manager assigns the next available sequential directory
number to the phone.
•
Quickly enter phones into the Cisco Unified Communications Manager
database and modify any settings, such as the directory numbers, from
Cisco Unified Communications Manager.
Move auto-registered phones to new locations and assign them to different
•
device pools without affecting their directory numbers.
Cisco recommends that you use auto-registration to add fewer than 100 phones to
your network. To add more than 100 phones to your network, use the Bulk
Administration Tool (BAT). See the
page
2-14.
Auto-registration is disabled by default. In some cases, you might not want to use
auto-registration: for example, if you want to assign a specific directory number
to the phone, or if you plan to implement authentication or encryption, as
described in Cisco Unified Communications Manager Security Guide. For
information about enabling auto-registration, refer to "Enabling
Auto-Registration" in Cisco Unified Communications Manager Administration
Guide.
When you configure the cluster for mixed mode through the Cisco CTL client,
auto-registration is automatically disabled. When you configure the cluster for
non-secure mode through the Cisco CTL client, auto-registration is automatically
enabled.
Related Topics
Adding Phones with Auto-Registration and TAPS, page 2-13
•
Preparing to Install the Cisco Unified IP Phone on Your Network
"Adding Phones with BAT" section on
OL-14587-01