Cisco 7931G - Unified IP Phone VoIP Посібник з адміністрування - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник з адміністрування для IP-телефон Cisco 7931G - Unified IP Phone VoIP. Cisco 7931G - Unified IP Phone VoIP 17 сторінок. For cisco unified callmanager express 4.0
Також для Cisco 7931G - Unified IP Phone VoIP: Посібник користувача (20 сторінок), Посібник з адміністрування (10 сторінок), Посібник з адміністрування (20 сторінок), Інструкція з монтажу (4 сторінок), Посібник (30 сторінок), Посібник з адміністрування (12 сторінок), Короткий довідник (2 сторінок), Коротка довідкова картка (2 сторінок), Посібник користувача (15 сторінок)

Adding Phones to the Cisco Unified Communications Manager Database

Adding Phones with Auto-Registration

Note

Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 6.1

2-12

Chapter 2

By enabling auto-registration before you begin installing phones, you can:

Add phones without first gathering MAC addresses from the phones.

•

Automatically add a Cisco Unified IP Phone to the Cisco Unified

•

Communications Manager database when you physically connect the phone

to your IP telephony network. During auto-registration, Cisco Unified

Communications Manager assigns the next available sequential directory

number to the phone.

•

Quickly enter phones into the Cisco Unified Communications Manager

database and modify any settings, such as the directory numbers, from

Cisco Unified Communications Manager.

Move auto-registered phones to new locations and assign them to different

•

device pools without affecting their directory numbers.

Cisco recommends that you use auto-registration to add fewer than 100 phones to

your network. To add more than 100 phones to your network, use the Bulk

Administration Tool (BAT). See the

page

2-14.

Auto-registration is disabled by default. In some cases, you might not want to use

auto-registration: for example, if you want to assign a specific directory number

to the phone, or if you plan to implement authentication or encryption, as

described in Cisco Unified Communications Manager Security Guide. For

information about enabling auto-registration, refer to "Enabling

Auto-Registration" in Cisco Unified Communications Manager Administration

Guide.

When you configure the cluster for mixed mode through the Cisco CTL client,

auto-registration is automatically disabled. When you configure the cluster for

non-secure mode through the Cisco CTL client, auto-registration is automatically

enabled.