Ricoh SP 311DNW Getting Started Manual - Page 39
Browse online or download pdf Getting Started Manual for Printer Ricoh SP 311DNW. Ricoh SP 311DNW 45 pages. Network settings guide
Also for Ricoh SP 311DNW: Quick Installation Manual (2 pages), Specifications (4 pages), Installation Manual (2 pages)
Authentication Select authentication method:
Encryption Select an encryption method.
WEP Key Max.
Length
WEP Key Valid
Characters
7. When finished, click [Apply]
8. Turn printer power switch Off. Wait a moment, and turn On.
9. Next, install Printer Driver & Utility. See
Note:
For further information on Smart Organizing Monitor, please refer to the User Guide, p60.
•
Open System
•
Shared Key
•
WPA2-PSK
•
Mixed Mode WPA/WPA2
•
Note: If Ad Hoc is selected for [Communication Mode], you can select only [Open
System] and [Shared Key].
If [Ad-Hoc] is selected for [Communication Mode], you can select only [None] and
[WEP].
[None]
•
When it is ON, communication will not be secured by encryption.
[WEP]
•
When it is ON, communication will be encrypted in WEP (Wired Equivalent
Privacy).
Specify [WEP Key Length], [WEP Transmit Key ID], and [WEP Key Format] and
enter [WEP Key]. The following table shows the number and types of characters
you can enter, depending on the key settings.
WEP Length is 64 bits
WEP format is Hex
10 characters
0-9, A-F, a-f
[WPA2-PSK]
•
When this is selected, communication will be encrypted with WPA2 (Wi-Fi
Protected Access 2). Enter a value in [WPA Passphrase] that contains from 8 to
64 characters.
• [Mixed Mode WPA/WPA2]
When this is selected, communication will be encrypted with WPA (Wi-Fi
Protected Access) or WPA2 (Wi-Fi Protected Access 2). Enter a value in [WPA
Passphrase] that contains from 8 to 64 characters.
[OK] to save changes, and then click [Close].
3.2 Network Quick
RICOH SP 311DNw B&W Network Laser Printer
WEP format is
WEP format is
ASCII
5 characters
26 characters
0x20-0x7e
0-9, A-F, a-f
Install.
Getting Started Guide
WEP Length is 128 bits
WEP format is
Hex
ASCII
13 characters
0x20-0x7e
39