Cisco 1805 Hardware Installation Manual - Page 7
Browse online or download pdf Hardware Installation Manual for Network Router Cisco 1805. Cisco 1805 12 pages. Integrated services router
Also for Cisco 1805: Installing And Replacing (4 pages), Quick Start Manual (4 pages), Datasheet (10 pages)
Print Page
Chapter 8
Installing and Upgrading Internal Modules in Cisco 1805 Cable Routers
When you install an AIM, always wear an ESD-preventive wrist strap, and ensure that it makes good
Caution
contact with your skin. Connect the equipment end of the wrist strap to the metal part of the chassis.
Handle AIMs by the edges only. AIMs are ESD-sensitive components and can be damaged by
Caution
mishandling.
Accessory Kit to Use
Some AIMs are provided with multiple accessory kits that contain different configurations of mounting
hardware. Mounting hardware for the Cisco 1805 cable router consists of two machine thread metal
standoffs, two machine thread metal screws, and one plastic standoff.
To install an AIM module on the Cisco 1805 cable router, use the hardware in mounting kit 69-1316-01.
Installation Procedure
To install the AIM, perform the following steps. You need a number 2 Phillips screwdriver or flat-head
screwdriver to complete this procedure.
Find the metal standoff attachment locations on the system board near the AIM connector, indicated by
Step 1
a star pattern, as shown in
Figure 8-7
System board
Install the two metal standoffs from the accessory kit into the system board in the metal standoff
Step 2
attachment locations. Use a 1/4-inch nut driver to tighten the standoffs. Locations for AIM standoffs are
denoted by a star pattern around the standoff mounting holes.
Make sure that the standoffs are installed straight. Tighten them gently but firmly. The shoulder must be
Caution
seated tightly against the system board.
OL-14661-01
Figure
8-7.
Location of Metal Standoff Attachment Locations
Cisco 1805 DOCSIS Cable Router Hardware Installation Guide
Modules Internal to the Cisco 1805 Cable Router
AIM connector
8-7