Cisco 1805 Посібник з встановлення обладнання - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник з встановлення обладнання для Мережевий маршрутизатор Cisco 1805. Cisco 1805 12 сторінок. Integrated services router
Також для Cisco 1805: Встановлення та заміна (4 сторінок), Посібник із швидкого старту (4 сторінок), Технічний паспорт (10 сторінок)

Chapter 8

Installing and Upgrading Internal Modules in Cisco 1805 Cable Routers

When you install an AIM, always wear an ESD-preventive wrist strap, and ensure that it makes good

Caution

contact with your skin. Connect the equipment end of the wrist strap to the metal part of the chassis.

Handle AIMs by the edges only. AIMs are ESD-sensitive components and can be damaged by

Caution

mishandling.

Accessory Kit to Use

Some AIMs are provided with multiple accessory kits that contain different configurations of mounting

hardware. Mounting hardware for the Cisco 1805 cable router consists of two machine thread metal

standoffs, two machine thread metal screws, and one plastic standoff.

To install an AIM module on the Cisco 1805 cable router, use the hardware in mounting kit 69-1316-01.

Installation Procedure

To install the AIM, perform the following steps. You need a number 2 Phillips screwdriver or flat-head

screwdriver to complete this procedure.

Find the metal standoff attachment locations on the system board near the AIM connector, indicated by

Step 1

a star pattern, as shown in

Figure 8-7

System board

Install the two metal standoffs from the accessory kit into the system board in the metal standoff

Step 2

attachment locations. Use a 1/4-inch nut driver to tighten the standoffs. Locations for AIM standoffs are

denoted by a star pattern around the standoff mounting holes.

Make sure that the standoffs are installed straight. Tighten them gently but firmly. The shoulder must be

Caution

seated tightly against the system board.

OL-14661-01

Figure

8-7.

Location of Metal Standoff Attachment Locations

Cisco 1805 DOCSIS Cable Router Hardware Installation Guide

Modules Internal to the Cisco 1805 Cable Router

AIM connector

8-7