Clarke-tech VBOX V4000 User Manual - Page 9
Browse online or download pdf User Manual for Antenna Clarke-tech VBOX V4000. Clarke-tech VBOX V4000 12 pages. 2-in-1, full-function antenna positioner for motorized satellite antenna systems
Print PageRecall saved satellite position:
With the following procedure, you can move the dish to any stored position.
1. Using the number keys on the remote, enter the satellite position shown above,
or one that you have programmed in; or
2. Press the
the number and name of the new position. After setting the position name, the
display will flash the number and name of the position.
3. Press OK key to confirm. The actuator will move to the stored position and the
display will show the position name and number. If the position has a set
name and number, the display will show the name of the position. If the
position has only a number, the display will show the number in the position
you choose.
PS: Once you choose a satellite and the actuator is moving, you can press any key on
the remote to immediately stop the actuator.
Re-synchronize all the Satellite Positions:
In case the positions are not correct or the picture is not clear on any
satellite, the shift (re-sync) function can correct all the positions
simultaneously.
1. Use the RECALL operation to move the actuator or H-H mount to a
stored position (for example, "NSS" and "P03") as a reference position
for "re-sync" operation.
2. Press and hold the Resync key for more than 5 seconds. The LED will
flash RESYNC and the name or number of the position.
3. Press 3 3 3 3 MANUAL4 4 4 4 to fine-tune the actuator or
strongest signal.
4. Press the OK key to confirm the operation. The display will show the
name or "PXX" again (for example "NSS" and "P03"). The rest of the
satellite positions in memory will also be fine-tuned. The following
drawing shows the operation.
Imported and distributed by satmedia GmbH Germany www.satmedia.com
or
keys to choose the satellite position. The display will show
H-H mount to get the