Dogtra Edge Owner's Manual - Page 12

Browse online or download pdf Owner's Manual for Pet Care Product Dogtra Edge. Dogtra Edge 19 pages. Remote controlled dog training collars
Also for Dogtra Edge: Owner's Manual (19 pages), Product Manual (14 pages), Owner's Manual (20 pages), Code Setting Manual (2 pages)

Print Page

11. Code Setting

To set the coding for the Dogtra EDGE transmitter to an existing

receiver/collar, or an Additional receiver/collar, follow the steps below.

*Attention: Turn the mode selection dial to "P", or "L", to check that

unit has been coded properly.

1. Start by turning on the transmitter

by holding down the on/off button

on the back of the transmitter.

2. Set the transmitter's intensity dial

to "0", and the mode selection dial

to "C".

3. In the off position hold down the

receiver/collar on/off button until

the green LED indicator light

begins to blink rapidly.

4. Immediately press the button on

the transmitter of the color you

would like the receiver/collar to be

coded to.

12. How to change the length of the contact points

The Dogtra EDGE comes equipped with standard 5/8" contact points

that can be extended to 3/4" contact points, for use with dogs with

longer coats.

To increase the contact point length from 5/8" to 3/4", follow the steps

below.

1. Using the included adjustment tool with the side marked 5/8",

unscrew the contact points counter-clockwise.

2. Place the contact point extension over the exposed threads, flat side

down.

3. Place the contact points over the extensions and tighten the contact

points and extensions clockwise using the adjustment tool with the

side marked 3/4".

* Caution: Tighten until firmly in place. Be careful not to over tighten.

To shorten the contact points back to the standard 5/8", start with the

adjustment tool with the side marked 3/4", remove the contact point

extensions, and tighten the contact points with the adjustment tool with

the side marked 5/8".