Dogtra Edge Руководство пользователя - Страница 12

Просмотреть онлайн или скачать pdf Руководство пользователя для Средство для ухода за домашними животными Dogtra Edge. Dogtra Edge 19 страниц. Remote controlled dog training collars
Также для Dogtra Edge: Руководство пользователя (19 страниц), Руководство по эксплуатации (14 страниц), Руководство пользователя (20 страниц), Руководство по настройке кодов (2 страниц)

11. Code Setting

To set the coding for the Dogtra EDGE transmitter to an existing

receiver/collar, or an Additional receiver/collar, follow the steps below.

*Attention: Turn the mode selection dial to "P", or "L", to check that

unit has been coded properly.

1. Start by turning on the transmitter

by holding down the on/off button

on the back of the transmitter.

2. Set the transmitter's intensity dial

to "0", and the mode selection dial

to "C".

3. In the off position hold down the

receiver/collar on/off button until

the green LED indicator light

begins to blink rapidly.

4. Immediately press the button on

the transmitter of the color you

would like the receiver/collar to be

coded to.

The Dogtra EDGE comes equipped with standard 5/8" contact points

that can be extended to 3/4" contact points, for use with dogs with

longer coats.

To increase the contact point length from 5/8" to 3/4", follow the steps

below.

1. Using the included adjustment tool with the side marked 5/8",

unscrew the contact points counter-clockwise.

2. Place the contact point extension over the exposed threads, flat side

down.

3. Place the contact points over the extensions and tighten the contact

points and extensions clockwise using the adjustment tool with the

side marked 3/4".

* Caution: Tighten until firmly in place. Be careful not to over tighten.

To shorten the contact points back to the standard 5/8", start with the

adjustment tool with the side marked 3/4", remove the contact point

extensions, and tighten the contact points with the adjustment tool with

the side marked 5/8".