CYP CMIR-882 Operation Manual - Page 9

Browse online or download pdf Operation Manual for Matrix Switcher CYP CMIR-882. CYP CMIR-882 20 pages. 8x8 bi-directional infrared matrix

Print Page

6.2 Rear Panel

A
B
RS232
AUX
RS232
MAIN
1
2
1
RS-232 AUX: Connect to a device that can be controlled (via D-Sub
9-pin male cable) by RS-232 commands e.g. the 8x8 HDMI Matrix.
2
RS-232 MAIN: Connect to a PC or control system with D-Sub 9-pin
male cable for the transmission of RS-232 commands.
3
TV In A~H: Connect to the supplied IR extender cables for IR signal
reception, the signal will be relayed to the designated source
device via the IR Blaster. Ensure that the remote being used is
within the direct line-of-sight of the IR extenders.
TV In All: Connect to a single IR extender cable for IR signal
reception, the signal will be relayed to all Source outputs (1~8)
at the same time. Ensure that the remote being used is within the
direct line-of-sight of the IR extender.
TV Out A~H: Connect to the supplied IR blaster cables for IR signal
transmission, IR signals will be relayed from the designated Source
IR extender. Place the IR blasters in direct line-of-sight of the
equipment to be controlled.
TV Out All: Connect to a single IR blaster cable for IR signal
transmission, IR signals will be relayed from all Source inputs (1~8)
at the same time. Place the IR blaster in direct line-of-sight of the
equipment to be controlled.
4
Source In 1~8: Connect to the supplied IR extender cables for IR
signal reception the signal will be relayed to the designated TV
output device via the IR Blaster. Ensure that the remote being used
is within the direct line-of-sight of the IR extenders.
Source In All: Connect to a single IR extender cable for IR signal
reception, the signal will be relayed to all TV outputs (A~H) at the
same time. Ensure that the remote being used is within the direct
line-of-sight of the IR extender.
Source Out 1~8: Connect to the supplied IR blaster cables for IR
signal transmission, IR signals will be relayed from the designated
TV output IR extender. Place the IR blasters in direct line-of-sight of
the equipment to be controlled.
TV
C
D
E
F
G
H
3
All
Out
1
2
3
4
In
SOURCE
5
6
7
8
All
DC 5V
4
5
4