Door-Gard 232iLM Instructies voor installatie en programmering - Pagina 6

Blader online of download pdf Instructies voor installatie en programmering voor {categorie_naam} Door-Gard 232iLM. Door-Gard 232iLM 8 pagina's. Keypad

Pagina afdrukken

Programming the 232iLM Keypad

The SSWiLM keypad has it's own local programming options. All user codes and other access control features are

programmed into the controller. Refer the Self-Contained Access Control Programming Guide for those features. The

programming options chart below shows all the programming commands available in the SSWiLM.

To program the SSWiLM you ﬁ rst must enter program mode.

To enter program mode enter the following on the keypad: 099 # program code ✱ (default program code is 6789).

Keypad Default Settings

Option

Local Program Code

Visual Keypress Feedback Enabled

Keypad Illumination

Programming Options Chart

Command/Action

Command 90

Change Local Program Code

Command 91

Set/Clear Keypad Options

(options below, defaults in bold)

Option

0 – Visual Keypress Feedback

1 – Audio Keypress Feedback

11 – Keypad Illumination

12 – Keypad Dimming

13 – Door Bell Select

Command 92

Set Door Bell Duration

Command 96

Reset Keypad to Default Settings

Exit Program Mode

Testing the Keypad

After installing the keypad, it is recommended that you perform the keypad self-test once a year, to ensure that the keypad

is working properly.

To perform the self-test, with the unit powered up, press the following keys on the keypad: 7890 # 123456 ✱

●

If all 12 keypresses are accepted, the keypad enters self-test mode.

●

The LEDs alternate three times followed by the sounder beeping three times.

●

When ﬁ nished the yellow LED starts ﬂ ickering rapidly.

Press ✱ to clear.

●

Default Setting

6789

Enabled

Keys to Enter/Details

90 # 0 # 0 # new code ✱ new code ✱ (default = 6789)

91 # option # set/clear # ✱ ✱

Clear

0 = Disabled

0 = Disabled (always bright)

0 = Disabled

92 # 4 # time # ✱ ✱

92 # 4 # 0 # ✱ ✱

96 # 0 # 0 # ✱ ✱

Press the ✱ Key

232iLM Keypad Installation & Programming

Option

Audio Keypress Feedback Enabled

Door Bell Select

Keypad Dimming

Set

1 = Enabled

Set timed output (1 – 99 seconds)

Set to continuous

Default Setting

Continuous

Enabled

6-050800 X2